Pat’s Perspective – Installing a spoiler correctly.

Just installed a spoiler in the shop today, and wanted to show you guys how it was done. Check out some of the pictures below! First we cleaned the surface of dirt and spots, to make sure it is clean before we start. Then we whipped it down with rubbing alcohol (shown with yellow shammy), to clear the surface again of any leftovers. After that, the spoiler can be measured and fitted into place. This is done with the special tape underneath the spoiler, by only peeling part of the tape. Then when the one side is stuck, you can pull off the rest of the tape in a zipper fashion. It just shows, put the time and effort into a job and it pays off.

0 comments

Write a Comment

Fields with * are required